Need an account?
DRL design at bottom...
Fuse box with DIM/DRL MODULE and FAN NO. 2 removed, DRL on right is empty
Cool, plenty of space!
View of right front and rear muflaps installed.
Push black button you see on the right, slide grey arm clockwise and it comes out. Grab edge of lip on upper edge next to hole, and push grey connector out from slot through hole seen at the bottom.
Used tiny screw driver to push in the little hole of slot 2, while pulling out the blue/black wire. Had to do it again in the long slot to get it past that hole as well.
Slid grey connector back into connection 8 with blue harness attached.
Slid fuse holder into first available slot like shown in instructions.
Connected blue/black wire removed to main harness connector towards the right, snapped the "cover" to make it permanent, then attached main harness to small blue harness on the left. Barely visible is ground in the background.
Yes, light is working!!!
Relay attached with electrical tape to harness per instructions. Taped red wire to SAM to tidy it up a bit. Ground in clear view to the left.
Put back footwell foam. My little battery maintainer harness peaking out of the hole in the lower right.
Inside of side panel
Holes drilled and mounted
Roof panel removed
Wire run mock up
Open fuse slots
Battery with maintainer harness
Side Panel removed/Wire run mock up
Top of SAM